ATLAS Quick Gear Change Handbook for 10 “Lathe Manual

$35.00

Description

Number of Pages: 44

This is a reproduction of an original Atlas Quick Change Attachment Hand Book for a 10-inch lathes. I combined the charts on the same page while maintaining the original size, but I enlarged pages without charts so you can see all the details. So all 72 pages of the original manual are included.

 

 

I have the 10-F Quick Change Installation Manual as well.

 

 

Contents:

Operating   Instructions………………………………………………… 1-5
Lubrication Chart……………………………………………………………. 6
TABLE I — Gear Set-ups for Odd Threads and Feeds…………. 7-59
TABLE II —Gear Set-ups for Metric Threads…………………….. 60

Gear Set-ups for Coil Winding TABLES III – XII

American Steel and Music Wire Gauge -TABLE III……………… 61-62
Enamel Covered Magnet Wire -TABLE IV…………………………. 63

American or Browne and Sharpe

    Wire Gauge -TABLE V……………………………………………….. 64-65
Washburn and Moen or Steel Wire Gauge -TABLE VI…………. 66
Double Cotton Covered Magnet Wire -TABLE VII……………… 67
Single Cotton Covered Magnet Wire -TABLE VIII………………. 68
Double Silk Covered Magnet Wire -TABLE IX…………………… 69
Single Silk Covered Magnet Wire -TABLE X……………………… 70

Enamel and Single Cotton Covered

    Magnet Wire -TABLE XI…………………………………………….. 71

Enamel and Single Silk Covered

    Magnet Wire -TABLE XII……………………………………………. 72

Overview:
I have collected this information for many years and have found the information they contain to be priceless in using and setting up the machines properly. I believe this manual will be a valuable resource of knowledge that will provide a lot of helpful information that is often hard to find. My manuals are not photocopies. I maintain a high standard of quality in my reproductions. Most of the manuals I reproduce look better than their originals. I have professionally digitally edited every page, and removed stains, wrinkles and handwriting. All of the manuals are printed on thick white paper to withstand shop wear and tear.