Description
Number of Pages: 30
This is a reproduction, not a photocopy, of an original Norton 6×18 inch Surface Grinder Instructions and Parts manual. This manual contains information on safety, installation, operating controls, lubrication, and parts diagrams of all the parts.
Contents
INTRODUCTION...................................3OPERATIONUncrating and Handling........................10Mounting the Grinding Wheel...................10Greasing and Oiling...........................11Oil for Hydraulic System......................11Table Dogs....................................11Wet and Dry Grinding..........................11Operating Levers..............................11Starting the Table............................12
Bleeding the Hydraulic System.................12
Cross Peed Dogs...............................13
Setting the Amount of Cross Peed..............14
Truing the Grinding Wheel.....................14
Grinding the Work.............................15
SERVICING
Table Ways....................................15
Saddle........................................15
Spindle Bearing and End Thrust................15
Ball Bearing Spindle..........................16
Replacing Spindle.............................16
Mounting Spindle Belt.........................16
Vee Type Belt.................................16
Plat Belt.....................................18
Vertical Slide Gib............................18
Vertical Spindle..............................18
Hydraulic Pressure............................18
CONSTRUCTION
The Hydraulic System..........................19
Reverse and Speed Control Valves..............21
Hand Traverse.................................25
Cross Peed....................................25
Vertical Peed.................................25
In the Event of Difficulty....................28
Overview
I have collected this information for many years and have found the information they contain to be priceless in using and setting up the machines properly. I believe this manual will be a valuable resource of knowledge that will provide a lot of helpful information that is often hard to find. My manuals are not photocopies. I maintain a high standard of quality in my reproductions. Most of the manuals I reproduce look better than their originals. I have professionally digitally edited every page, and removed stains, wrinkles and handwriting. All of the manuals are printed on thick white paper to withstand shop wear and tear.
